INSTRUCTIONS

VIDEOS:

- Apply the decals.

- Remove the decals safely.

APPLY THE DECALS:

If the left (L) and right (R) sides are different, this will be indicated on the bags. The right side (R) is the chain side. 

The arrow ⬆️ indicates the orientation of the letter.

The numbers: 1, 2, 3… indicate the application order and group identical letters. Some decals look the same, but they are not.

SCOTT SPARK: Remove the lower shock cover before applying the decals.

CLEAN THE SURFACE: It must be clean and dry.

APPLY THE TRANSFER TAPE:

1. Remove the inner waste pieces (Fold slightly for easier removal). 

2. Cut out the letters you are going to apply with scissors.

 

3. Cut a piece of transfer tape (Enough to cover the decal to be applied).

 

4. Place the transparent transfer tape over the letters and press over the tape with a card.

 

5. The decals should remain stuck to the transfer tape. If not, press again and remove carefully.

APPLY THE LETTERS:

6. Position the letters as centrally as possible. Do not apply pressure so you can remove or reposition them if they do not align properly.

The letters are oversized. They should be CENTERED over the original design. 

 

7. Once applied, press firmly so they adhere to the bicycle. You can do this by hand or using a card or plastic squeegee.

 

8. Slowly remove the transparent transfer tape. The decals should remain stuck to the bicycle's surface. 

WAIT 24 HOURS for the decals to fully adhere before cleaning them with pressurized water or a cloth.

REMOVE THE DECALS:

APPLY HEAT TO THE DECALS USING A HAIRDRYER and remove the decals by hand.

CAUTION: Failure to remove them using heat may damage the bicycle's paint.

The user expressly assumes responsibility for applying and removing the decals. We accept no liability for any damage resulting from removing the decals. Users are advised to follow the instructions provided to avoid possible damage.